Panasonic Lumix DMC-FZ2500 Owner's Manual page 66

Others
The picture is not played back.
There are no recorded pictures.
• Is the card inserted?
• Is this a folder or picture which was processed in the PC?
If it is, it cannot be played back by this unit.
> It is recommended to use the software "PHOTOfunSTUDIO" (P59) to write pictures from
PC to card.
• Has [Playback Mode] been set for playback?
> Change to [Normal Play].
Cannot play back motion pictures.
• Motion pictures recorded with a different [System Frequency] setting cannot be played back. (P53)
> Return the [System Frequency] setting to the one you used during the recording.
A Wi-Fi connection cannot be established.
Radio waves get disconnected.
Wireless access point is not displayed.
∫ General tips for using a Wi-Fi connection
• Use within the communication range of the device to be connected.
• Is any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz frequency operated
nearby?
> Radio waves may get interrupted when used simultaneously. Use them sufficiently away from the
device.
• When the battery indicator is flashing red, the connection with other equipment may not start or the
connection may be disrupted.
(A message such as [Communication error] is displayed.)
• If you place the camera on a metal table or shelf, the radio waves may be adversely affected. In such
cases, you may not be able to establish a connection. Move the camera away from the metal surface.
∫ About a wireless access point
• Check if the wireless access point to connect is in operating state.
• Check the radio wave condition of the wireless access point.
> Move this unit closer to the wireless access point.
> Change the location and orientation of the wireless access point.
• It may not display even if the radio waves exist depending on the setting of the wireless access point.
> Check the settings of the wireless access point.
> When the network SSID of the wireless access point is set not to broadcast, the wireless access point
may not be detected. Enter the network SSID to start the connection or enable the SSID broadcast of
the wireless access point.
When I try to set up a Wi-Fi connection with a Windows 8 PC, my user name and
password are not recognized, so I cannot connect to the PC.
• Some OS versions, including Windows 8, use two types of accounts: a local account and a
Microsoft account.
> Be sure to use the user name and password for the local account.
If you haven't set up a local account, please create one.
66
DVQX1028 (ENG)