JVC KW-V520BT Instruction Manual page 45

SETTINGS SETTINGS
❏ Setting the speakers—car type,
speaker size and crossover frequency
Preparation:
Select the appropriate crossover network mode
beforehand. (Page 44)
1
Display the <Car Setting> screen.
On the Home screen:
2
Select a car type (1), select the location
of the speakers (2)* , then display the
1
<Speaker Select> screen (3).
3
Select the speaker type (1), select the size
of the selected speaker (2), then display
the <X'over> screen (3).
• When a speaker is not connected, select
<None>.
• When setting the front speakers, also select
the speaker size for <Tweeter>.
4
Adjust the crossover frequency of the
selected speaker.
<TW Gain (L)>/ Adjusts the output volume of
<TW Gain (R)>
the tweeter (left/right). *
<TW FREQ>
Adjusts the crossover
frequency for the tweeter. *
<Gain>
Adjusts the output volume of
the selected speaker.
<HPF FREQ> Adjusts the crossover
frequency for the front or rear
speakers (high pass filter).*
<LPF FREQ>
Adjusts the crossover for the
subwoofer (low pass filter).*
<Slope>
Adjusts the crossover slope.*
<Phase> Selects the phase for the
subwoofer.*
* Speaker location selection is available only when <X'over
1
Network> is set to [2 way]. (Page 44)
* Appears only when the front speakers are selected.
2
Adjustable only when <Tweeter> is set to <Small>,
* 3
<Middle>, or <Large> on the <Speaker Select>
screen.
* Appears only when the front/tweeter or rear/mid range speakers
4
are selected.
When <X'over Network> is set to [2 way] (Page 44):
*
5
Appears only when the subwoofer is selected.
Not adjustable when <HPF FREQ> or <LPF FREQ> is set to
*
6
<Through>.
*
2 3
*
2 3
4
5
6
5
ENGLISH 45