Supercharger Mounting; Supercharger Drive Belt; Air Filter Assembly - Ford Mustang 1986 Installation Instructions Manual

11. SUPERCHARGER MOUNTING

*A. Place the oil drain hose onto the supercharger drain fitting and
secure with a hose clamp. Arrange the clamp screw housing so
it will not interfere with the mounting plate when installed.
*B. Feed the oil drain hose over the top of the smog pump and down
towards the oil pan fitting while lowering the supercharger into
position.
C. Secure the supercharger with five 3/8-16 x 1" bolts and AN
washers.
*D. Connect the lower end of the oil drain hose to the fitting on the
pan and secure with a hose clamp.
**E. Secure the remote drain hose away from the belt and other hoses
using tie-wraps.

12. SUPERCHARGER DRIVE BELT

1986-93 RENEGADE 5.0L KIT ONLY
NOTE: The factory water pump pulley must be
removed and replaced with an aftermar-
ket unit for proper supercharger drive belt
clearance. Also, an aftermarket electric
fan is recommended, although the factory
mechanical fan may still be retained with
minor clearance modifications.
A. Place the supercharger belt idler assembly on
the supercharger using the 12mm bolts and
washers. Position the thin head bolt nearest
pulley.
B. Fit the supercharger drive belt over the new
crank pulley and supercharger pulley.
C. Tension the belt by rotating the tensioner plate
and secure.
13. AIR FILTER ASSEMBLY (skip to step I for Renegade applications
and step J for S.H.O. applications)
A. Place the Vortech air filter cover against the inner fender
just behind the right headlight. Use it as a template to
mark and drill two 3/32" holes. Do not install the cover
at this time.
B. Insert the mass air flow (MAF) sensor into the back of the
air filter cover. Place the air filter with clamp, from the
inside, over the protruding MAF and the air filter flange.
Rotate the MAF so that the connector runs parallel to
the top as shown. Tighten the clamp.
C. Mount the air filter assembly behind the headlight and
secure with sheet metal screws provided.
D. Attach the 3" molded elbow to the supercharger with the
sleeve and clamps.
E. Connect the 3" flex tube to the molded elbow and the
back of the MAF with the 3" x 1" adapter sleeve on the
MAF (as a spacer) and secure with clamps.
F. Connect the air discharge tube to the throttle body and
supercharger with the sleeves and clamps provided.
10
* Engine oil fed kits only
** V3 kits only
Fig. 12-a
Fig. 13-a
P/N: 4FA020-010
© 2008 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
25MAR08 v4.0(86-93 5.0 Mus (4FA v4.0))