Smog Pump Hoses - Ford Mustang 1986 Installation Instructions Manual

7. MAIN BRACKET ASSEMBLY (cont'd.)
E. Attach the Vortech alternator brace
between the boss on the smog pump
and alternator with the 3/8-16 x 1" bolts.
On 1992 and later Mustangs, it may be
necessary to drill and tap the "blanked"
hole in the smog pump. To accomplish
this use an R size bit and a 3/8-16 size
tap.
F. Tighten all fasteners in the bracket/
accessory assembly.
G. Lower the entire assembly into position
and start all four fasteners that hold it
to the engine. Tighten all fasteners in a
progressive manner.
H. Reconnect alternator wires and use a tie
wrap to secure the wires.

8. SMOG PUMP HOSES

1986-93 RENEGADE
5.0L KIT ONLY
NOTE: Due to the location of the
Vortech Mondo bypass valve,
removal of the air injection hose
assemblies is required for proper
bypass valve installation. This
modification is for off-road use
only. Disregard the following steps
A thru E.
A. Separate the short hose and bent hose from
the air control valve and place the shorter hose
on the diverter valve (the valve closest to the
firewall) as shown.
B. Connect the air control valve to the short
hose.
C. Trim approximately 1-1/2", or as necessary, off
the longer straight portion of the bent hose for
proper fit.
D. Secure the hose as shown with the stock
clamps.
E. It may be necessary to reroute the vacuum
control line after the supercharger is in place.
DIVERTER VALVE AIR CONTROL V
SHORTEN THIS HOSE 1-1/2"
8
ALVE
SMOG PUMP
Fig. 8-a
P/N: 4FA020-010
© 2008 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
25MAR08 v4.0(86-93 5.0 Mus (4FA v4.0))