Dell W2306C Owner's Manual page 91

Problem
Poor picture quality when using a
device connected to the ANT/Cable
(coaxial) connector
wide LCD
Nothing appears on my
monitor
Possible Solution
Ensure wide LCD monitor is selected as the input source in the
1
Input Select menu. See "Input Select Menu" on page 85 for
more information.
Press Menu on the remote control, select Setup, and then select
2
Channel Setup. This resets the channels on your remote.
Check the aspect ratio settings in the TV Menu. Press the Menu
3
button on the remote control and select Size. For more
information on using the TV Menu, see "Using the TV Menu"
on page 84.
Reset the original factory defaults. Press Menu on the remote
4
control, select Setup, and then select Factory Reset.
Adjust the color temperature. Press Menu on the remote
5
control, select Picture, and then select Color Temperature.
The problem may be with your device, contact your service
6
provider.
Ensure the wide LCD monitor is turned on.
1
Verify that all the cables are properly connected to the wide
2
LCD monitor, including the power cable.
Check to see if there is a blue or amber light on the lower,
3
right-hand corner of the wide LCD monitor. A blue light
indicates the wide LCD monitor is on. An amber light, means
the wide LCD monitor is in power save mode.
Ensure the proper source is selected in the Input Select menu.
4
See "Input Select Menu" on page 85 for more information.
Reconnect any devices that are currently connected to the wide
5
LCD monitor. If you are using multiple devices, connect and
test one device at a time.
Connect another device that you know is working properly.
6
Reset the original factory defaults. Press Menu on the remote
7
control, select Setup, and then select Factory Reset.
Troubleshooting Your Wide LCD Monitor
91