Chicco PD348997B Assembly Instructions Manual page 3

NOTE: Left and right are determined by standing in front of and
facing the stroller and each Adapter Bracket is labeled
with an L or an R for your convenience.
3 Insert the U-shaped bar (A) into the openings on the front of
the adapter brackets. The A bar should be inserted all the way
so that the stoppers hit the plastic adapter brackets.
4 From the rear of the stroller, connect the second U-shaped
bar (B) by inserting it over the ends of the already installed
U-shaped bar (A) until it clicks into place and the green
indicator on top is displayed entirely.
5 Place car seat on the car seat adapter and press down firmly
until it clicks into place.
To remove car seat:
Follow the steps in your car seat' s instruction manual to remove
car seat from adapters.
To remove adapters:
Press gray release button on each adapter and pull upward to
remove.
WARNING:
• Keep these instructions for future reference.
• Read these instructions carefully before use. Your child' s safety
may be affected if you don't follow these instructions.
• NEVER leave child unattended.
• IMPORTANT! While the child is in the carseat, always use the
restraint system provided by the manufacturer.
• WARNING: Check that the car seat attachment devices are
correctly engaged before use.
• Accessories not approved by Baby Jogger® shall not be used.
• Only use replacement parts supplied or recommended by
Baby Jogger®.
• Wipe clean using a damp cloth.
3