DeWalt DW331 Original Instructions Manual page 11

Setting The Sawdust Blower (fi g. 1)
The sawdust blower conducts an adjustable stream
of air to the saw blade to keep the workpiece clear
of sawdust during operation.
Set the sawdust blower using the lever (d).
Low For working with metals,
when using coolants and
lubricants and for use with dust
extraction.
Intermediate For working with wood and
similar materials in low speed.
High For working with wood and
similar materials in high speed.
Mounting The Plastic Anti-Scratch
Shoe Cover (fi g. 4)
The anti-scratch shoe cover (l) reduces damage to
the surface of (sensitive) workpieces.
Click the cover onto the shoe as shown.
Mounting And Removing The Anti-
Splinter Shoe Insert (fi g. 5, 6)
The anti-splinter shoe insert (m) which fits close to
the saw blade reduces splintering of the workpiece.
The insert can be mounted both into the shoe and
the shoe cover.
1. Hold the insert (m) in the orientation as shown.
2. To mount the insert into the shoe (i):
a. Slide the edges (n) into the grooves (o).
b. Slide the insert back into position against the
shoe.
3. To mount the insert into the cover (l):
a. Slide the edges (n) behind the ribs (p).
b. Push the front end of the insert towards the
cover. The insert snaps into place.
4. To remove the anti-splinter shoe insert do the
above process in reverse order.
Dust Extraction (fi g. 7)
The dust extraction adaptor (q) in combination with
the dust extraction shroud (r) helps extracting the
dust from the workpiece surface, when connected
to a suitable dust extraction system.
1. Place the dust extraction shroud (r) onto the
finger guard (f) until it clicks in place.
2. Fit the dust extraction adaptor (q) to the tool as
shown.
3. Connect the hose of a suitable dust extraction
system to the adaptor.
WARNING: When appropriate, connect
a dust extraction system designed
in compliance with the applicable
directives regarding dust emission.
WARNING: Do not use a dust
extraction system without proper spark
protection when sawing metal.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Make sure your workpiece is well
secured. Remove nails, screws and
other fasteners that may damage the
blade.
• Check that there is sufficient space for
the blade underneath the workpiece.
Do not cut materials that exceed the
maximum cutting depth of the blade.
• Use sharp saw blades only. Damaged
or bent saw blades must be removed
immediately.
• Do not use the tool for sawing pipes or
tubes.
• Never run your tool without a saw
blade.
• For optimal results, move the tool
smoothly and constantly over the
workpiece. Do not exert lateral pressure
on the saw blade. Keep the shoe flat on
the workpiece and lead the cord away in
line with the tool. When sawing curves,
circles or other round shapes, push the
tool gently forward.
• Wait until the tool has come to a
standstill before removing the saw blade
from the workpiece. After sawing the
blade may be very hot. Do not touch.
EN G LI SH
9