Disassembly & Reassembly - Samsung DP14LS Service Manual

4 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
DP14L*/DP15L* monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
4-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. To remove the Rear Cover, you must use the special opening jig tool.
4-1-1 Cabinet Disassembly
1. With a pad beneath it, stand the monitor on its
front with the screen facing downward and
the base closest to you. Make sure nothing will
damage the screen.
2. Remove the Stand from the monitor.
(Refer to Stand manual)
3. Incline the monitor by lifting the rear of the
monitor.
4. Push the Opening jig each groove along the
top of the monitor till it makes a ÒttakÓ sound.
(2 grooves : Left and Right, Make sure each
snap is disengaged.)
DP14L*/DP15L*
Figure 1
Figure 2
5. Squeeze the hold-snap on bottom of the
monitor using your hand.
6. Insert the Opening jig into the groove then
release the hold-snap.
Figure 3
Figure 4
4-1