Yamaha RX-V675 Service Manual page 13

• SET MENU TABLE
MAIN MENU SUB-MENU
Speaker Auto Measure
Setup Result
Manual Power Amp Assign
Configuration
Distance
Level
Parametric EQ
Test Tone
Sound Setup Lipsync Delay Enable
Auto/Manual Select
Adjustment
PARAMETER
Front
Center
Surround
Surround Back
Front Presence
Subwoofer
Extra Bass
Bass Cross Over
Front L
Front R
Center
Surround L
Surround R
Surround Back L
Surround Back R
Front Presence L
Front Presence R
Subwoofer
Front L
Front R
Center
Surround L
Surround R
Surround Back L
Surround Back R
Front Presence L
Front Presence R
Subwoofer
Front L Band
Front R / Gain ▲ Gain: -20.0 to +6.0 dB, [0.0 dB], 0.5 dB step
Center
Surround L Frequency ▶ Frequency: 31.3 Hz to 16.0 kHz, [62.5 Hz]
Surround R / Gain ▲ Gain: -20.0 to +6.0 dB, [0.0 dB], 0.5 dB step
Surround Back L
Surround Back R Q
Front Presence L / Gain ▲ Gain: -20.0 to +6.0 dB, [0.0 dB], 0.5 dB step
Front Presence R
PEQ Data Copy
PEQ Data Clear
HDMI1 / HDMI2 / HDMI3 / HDMI4 /
HDMI5 / AV1 / AV2 / AV3 / AV4 / AV5 /
AV6 / V-AUX / AUDIO1 / AUDIO2
RX-V675/HTR-6066/RX-A730/TSR-6750
VALUE [INITIAL VALUE]
Optimizes the speaker configuration automatically using YPAO.
Not Available
[Basic] / 7ch +1ZONE / 5ch BI-AMP
Large / [Small]
* "Front" is automatically set to "Large" when "Subwoofer" is set to "None" .
Large / [Small] / None
Large x1 / Large x2 / Small x1 / [Small x2] / None
* This setting is not available when "Power Amp Assign" is set to "5ch BI-
AMP" , or when "Surround" is set to "None" .
[Use] / None
Use / None
[Normal] / Reverse
[Off] / On
* This setting is not available when "Subwoofer" is set to "None" , or when
"Front" is set to "Small" .
40 / 60 / [80] / 90 / 100 / 110 / 120 / 160 / 200 Hz
Meter / Feet
0.30 to 24.00 m, [3.00 m], 0.05 m step
1.0 to 80.0 ft, [10.0 ft], 0.2 ft step
-10.0 to +10.0 dB, [0.0 dB], 0.5 dB step
Manual / YPAO : Flat / YPAO : Front / YPAO : Natural / Through
* Select "ENTER"
▶ Band: #1 to #7
▶ Q: 0.500 to 10.080, [1.000]
Flat > Manual / Front > Manual / Natural > Manual
* Select "ENTER"
* Select "ENTER"
OK / CANCEL
[Off] / On
Disable / [Enable]
[Auto] / Manual
0 to 500 ms, [0 ms], 1 ms step
13