Operating Accessory Devices with the TV Remote
Once you have programmed your TV remote,
refer to page 27 to see how the remote func-
tions with accessory devices.
Before the remote will operate an accessory
device, you must select the correct mode:
CBL (cable box), VCR, DVD, SAT (satellite),
or AMP (amplifier).
1
Press the Select button to cycle through
the accessory modes. When the mode
you want lights up, stop pressing the
button. After a few seconds, the light
will begin blinking. The blinking
means that the remote is in the acces-
sory mode you have selected.
NOTE: The remote is in accessory
mode as long as the light keeps blink-
ing. If you do not use the remote for
60 seconds the light will switch off,
and the TV will go back to TV mode.
The 60-second timer restarts each time
you use the remote in an accessory
mode.
2
Point the front of the remote toward
the front of the accessory device, then
press the button to perform the desired
function.
H
H
ELPFUL
Press the Select button once to return the
remote to the TV mode.
Press the Select Button twice to select
another device by cycling through the
accessory mode choices.
c c C
I
HECK
T
You can change the duration of the time-out
mode by simultaneously pressing the Select
button and a digit button, 1–4. Using digit 1
will set the time-out to 15 seconds; digit 2, 30
seconds; digit 3, 60 seconds; and digit 4, 120
seconds. The default time-out setting after
you replace the batteries in the remote is 60
seconds. All modes will have the same time-
out setting.
INT
O
UT
GUIDE
POWER
SELECT
POWER
INFO
HIGH DEFINITION
INFO
SELECT
DNM
CC
SURR
TV
HD
1
SCREEN
FORMAT
SURF
®
®
®
®
PIP
P
AV+
ACTIVE
SLEEP
SAP
CONTROL
TIMER
CLOCK
AUTO
AUTO
26
Point the front of the remote
2
toward the front of the
accessory device, then press
the necessary buttons to per-
form the functions you
desire. Refer to pages 27 to
see the functions of the but-
tons in the respective acces-
sory modes.
To backlight the
remote control but-
tons, press and hold
the Select button for
two seconds. If you do not press
any remote buttons for five sec-
onds, the backlight switches off.
Each time you press a remote but-
ton while the backlight is on, the
five-second time-out function is
reset. After the backlight switches
off, you must press and hold the
Select button for two seconds to
turn it back on.