Panasonic DMR-XS380EB Service Manual page 24

Error Code Diagnosis contents
NO READ Disc read error
HARD Drive error
ERR
SELF Restoration operation
CHECK
PLEASE Unit is in termination process Unit is in termination process now.
WAIT
UNFOR- Unformatted disc error
MAT
IR ERR IR communication error
No REC Recording is impossible
HDD [HDD ERR] is
ERROR when start up of HDD was
failed.
(Except error of setting of
Power on Stand-by)
HDD NG Power on Stand-by setting
error
NoERAS Erase is impossible
NoWRIT Writing is impossible
PROG Timer programmes are full
FULL
Description
*A disc is flawed or dirty.
*A poor quality failed to start.
*The track information could not be read.
The drive detected a hard error.
Since the power cord fell out during a
power failure or operation, it is under resto-
ration operation.
*It will OK, if a display disappears automati-
cally. If a display does not disappear, there
is the possibility that defective Digital P.C.B.
/ DVD drive.
"BYE" is displayed and power will be turned
off.
In case "Quick Start" of setup menu is ON,
it is displayed in restoration operation for
AC off.
You have inserted an unformatted DVD-
RAM or DVD-RW that is unformatted or
recorded on other equipment.
[IR ERR] is displayed when communication
between Timer microprocessor and IR
microprocessor fails.
[No REC] is displayed when recording is
impossible due to the defect, dirt or wound
of media.
displayed a) When normal start up was failed.
b) When start up at HDD boot was failed.
c) When start up from state of P-OFF was
failed.
d) When start up from state of HDD SLEEP
was failed.
[HDD ERR] is displayed when above each
start up of HDD was failed.
*In case b), tray opens automatically and
[HDDERR] is displayed until version up
disc is inserted.
[HDD NG] is displayed when power on
Stand-by setting of HDD is NG or when
HDD which power on Stand-by is not set to
is used.
Please try to replace HDD with genuine
HDD as service parts.
You cannot delete items on this disc.
The disc may be damaged. Use a new
disc.
You cannot write to this disc.
The disc may be damaged. Use a new
disc.
There are already 32 timer programmes.
Delete unnecessary timer programmes.
Monitor Display
"Cannot read.
Please check the
disc."
"DVD drive error." Display for 5 seconds.
No display
No display
No display
No display
No display
No display
No display
No display
No display
24
Automatic FL display
The character indication flows side-
ways.
The character indication flows side-
ways.
The character indication flows side-
ways.
The character indication flows side-
ways.