Audiovox VE 700 Installation And Operation Manual page 17

SETTING and ACTIVATING ALARM
NOTE: The VE700 must be turned "OFF" when performing the following procedure.
1) Press the SET button (1) twice to and VE700 is in alarm mode indicated by six flashing LED's.
A preset time will be displayed with the minutes portion blinking.
(Alarm ACTVATED mode, Alarm indicator " AL" on).
NOTE: If a series of dashes appear (--: --, Alarm DEACTIVATED mode) press the FM/AM button
once to switch to the Alarm ACTVAVTED mode.
2) Press the CH up/down buttons to set the desired hour/minute. When setting the check the
AM/PM indicator to assure the proper setting.
3) Press the SEEK buttons to toggle between the hours and minutes.
4) Press the ON/OFF button or T/F button. The alarm is now set and activated.
Once the alarm is set it will sound each day at the same time as long as it is activated.
DEACTIVATING ALARM
1) Press the SET button twice to enter the alarm mode.
2) Press the FM/AM button once. The set time disappear from the Display Window and a series
of will appear (--: --, Alarm DEACTIVATED mode, Alarm indicator "AL" off).
3) Press the ON/OFF button or T/F button. The alarm is now deactivated.
NOTE: The set time will be stored in memory and can be reactivated whenever desired by performing
steps 1)-3) of the DEACTIVATING ALARM procedure.
SETTING THE ALARM TONES
1) Press the SET button twice (power off).
2) Press the A/V button once to hear the alarm tone.
NOTE: Alarm must be in the "Activated" mode to hear tones.
3) Each time CH up/down button is pressed it will select different tone.
4) Press the ON/OFF button or T/F button to select this tone.
5) When the alarm sounds, press the set button to turn it off.
SETTING THE CABLE TV MODE
1) Press the SET button three times to enter the cable configuration mode.
2) CABL appears on the display.
3) Press the CH up/down button to select the cable mode (STD/IRC/HRC).
4) When the desired mode is reached, press the PWR button or T/F button to confirm.
- 17 -