Operation (Local) - Toshiba G9 ASD Quick Start Manual

RS485
Communication Option Board
RX2 Option (AI1)
Option V/I
UP/DOWN Frequency
Pulse Input (Option)
Pulse Input (Motor CPU)
Binary/BCD Input (Option)
Display Unit
This parameter sets the unit of measurement for current and voltage values displayed on the EOI.
Wizard: Finish
This is the final screen of the Startup Wizard. The basic parameters of the ASD have been set. Click
Finish to return to the

Operation (Local)

Note: See the section titled
Remote operation.
To turn the motor on perform the following:
1. Connect the CC terminal to the ST terminal.
2. Press the Mode key until the Frequency
Command screen is displayed.
3. Press the Local/Remote key to enter the Local
mode (green Local LED illuminates).
4. Turn the Rotary Encoder clockwise until the
desired Frequency Command value is
displayed in the SET field of the LCD Screen.
5. Press the Run key and the motor runs at the
Frequency Command value.
Note:
6. Press the Stop-Reset key to stop the motor.
G9 ASD Quick Start Guide
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Program mode. Additional application-specific programming may be required.
Electronic Operator Interface on pg. 24
The speed of the motor may be changed while the motor is running by using the
Rotary Encoder to change the Frequency Command value.
for information on
Frequency Command Screen
61