Sony STR-DA6400ES Service Manual page 15

QQ
3 7 63 1515 0
Using On-screen Remote (Quick Click)
Operating components or lighting connected to the receiver using the on screen
remote (Quick Click)
You can control components connected to the receiver, a projector, and the light control unit using the on-screen remote on the TV screen.
TE
L 13942296513
Preparing Quick Click
It is necessary to connect the IR Blaster to use Quick Click. Connect the IR Blaster according to following instructions.
Connecting the IR Blaster
Attach the supplied IR Blaster to components
connected to the receiver. You can control
components connected to the receiver via the
IR Blaster using the on-screen remote control.
www
IR Blaster
(supplied)
Infrared transmitter
.
Remote sensor
http://www.xiaoyu163.com
On-Screen remote (Quick Click)
After referring to the operating instructions of
the components connected to the receiver
make sure to place the IR Blaster just above or
below the remote sensor. Remote sensors on
Sony Recorders and other products are
identified by the
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
IR Blaster
Common Components
Projector TV
Source Components
Q Q
3 6 7 1 3 1 5
symbol.
co
.
STR-DA6400ES
9 4 2 8
Light
0 5 8 2 9 9 4 2 8
Note
Do not remove the backing paper from the IR
Blaster yet.
After configuring the settings, remove the backing
paper from the IR Blaster and fix it in place.
Place the components and the IR Blaster as
follows when you want to operate two
components with the IR Blaster.
IR Blaster
Remote sensors
If the infrared receivers on the two
components do not line up as shown in the
illustration above, you must purchase an
m
optional IR Blaster (VM-50, not supplied) and
install it.
Note
For details on how to set up a component, refer to the
operating instructions of the component.
Tip
If the IR Blaster cable is too short, use a 3.5 mm jack
extension cable (not supplied).
9 9
9 9
15