SRAM Elixir 5 Service Manual page 23

5
determine where you need to cut the hose by holding it up to
the lever in the position you like. Make sure to leave a gentle
bend in the hose with enough length to freely turn the bars all
the way from side to side. double-check this measurement
because you can't go back after you cut.
the groove in the lever nose marks the spot where
you'll cut the hose. Cut the hose using hydraulic hose
cutters or very sharp cable housing cutters.
6
apply avid dot Grease to the threads of a new hose barb, the
compression fitting outer surfaces and compression nut
threads.
While holding the hose firmly, use a t10 toRX® to thread
the hose barb into the end of the hose until it is flush.
Slide a new compression fitting over the end
of the hose with the new hose barb.
7
Push the hose firmly into the lever until it stops.
While holding the hose in place, slide the compression
fitting and compression nut up to the lever or hose stop.
23
Measure twice, cut once!
avid brake hose length adjustment