Replacing The System Outer Foil And The Inner Blades - Panasonic ES8813 Operating Instructions Manual

Cleaning
3
4
6
ES8813(EU).indb 5
1. Disconnect the power cord
from the shaver.
. Apply some hand soap to the
outer foil.
3. Press the on/off switch for
more than  seconds to
activate the turbo mode for
"sonic" vibration cleaning.
• The battery capacity monitor
lamps blink randomly at the
same time.
• After about 0 seconds, it will
be automatically turned off,
or you can turn it off by
pressing the on/off switch.
4. Remove the system outer foil
and press the on/off switch for
more than  seconds to
activate the turbo mode for
"sonic" vibration cleaning and
clean it with running water.
5. Wipe off any drops of water
with a dry cloth.
6. Remove the system foil and
the foil frame to allow them to
dry completely.
Caution for turbo mode
• Shaving in turbo mode may damage your skin. Turn the shaver
off and then on again to cancel turbo mode.
• Do not place your fingers on the on/off switch while using the
shaver. This may cause the shaver to turn off or enter turbo
mode.
Lubrication
To maintain shaving comfort for a long time, it is recommended
that the oil provided with the shaver is used.
1. Switch off the shaver.
. Apply one drop of oil to each of the outer foils.
3. Raise the trimmer and apply a drop of oil.
4. Switch the shaver on, and run it for approximately five
seconds.
5. Switch off the shaver, and wipe off any excess oil from the
outer foils with a soft cloth.
Replacing the system outer foil and the inner
blades
system outer foil
inner blade
1Replacing the system outer foil
1
once every year
once every two years
1. Press the buttons and lift
upwards as illustrated.
. Insert the system outer foil by
pushing it downwards until it
clicks.
5
2007/01/29 14:56:34