Related Manuals for Panasonic ES8801
Summary of Contents for Panasonic ES8801
- Page 1 AC/Rechargeable Shaver Operating Instructions Model No. ES8801 ES8801 Before operating this unit, please read these instructions completely. Thank you for purchasing the Panasonic Rechargeable Shaver Model No. ES8801. Panasonic ES8801...
- Page 2 Both the foil and the blade have a limited service life. To keep a better result, we suggest you to replace the outer foil and the inner blade at reguler intervals. Both the foil and the blade are available in the department store or Panasonic service station.
- Page 3 -high -mid -low -charge status -high -mid -low -high -charge status -mid -low -charge status...
- Page 4 -high -mid -low -charge status...
- Page 5 Index ENGLISH Page CHINESE Page 12...
-
Page 6: Parts Identification
Parts identification • When charging the shaver for the first time or when it has not been (see fig. 1) in use for more than 6 months, the Protective cap charge status lamp may not illumi- System outer foil nate for a few minutes after opera- Inner blades tion. - Page 7 starts to blink. (Differs depending If you push and hold the 0/1 switch on the use situation.) for more than 2 seconds, it will activate the turbo mode for “sonic” A full charge will supply enough vibration cleaning. power for approx. 14 shaves (3 min- (see “Cleaning your shaver”) utes per shave for a normal beard).
-
Page 8: Using The Trimmer
Using the trimmer turbo mode for “sonic” vibration cleaning. (see fig. 6) At the same time, the lamps of the Slide the trimmer handle up to open Battery capacity monitor will flash the trimmer. around randomly. Place the trimmer at a right angle to Pour some water over the outer foil. -
Page 9: Brush Cleaning
Brush cleaning upward to remove it. Remove the inner blade one at a time by grasping Squeeze the foil frame release it firmly at both ends and pulling buttons and lift the foil frame upward straight away from the shaver. to remove it (see fig. - Page 10 Do not submerge the shaver for a • Use only the included adaptor long time. RE7-27 to charge the ES8801 • Do not wipe any part of the shaver shaver. with thinner, benzine or alcohol. • Dry the shaver completely before Clean it by using a cloth dampened charging it.
-
Page 11: Specifications
• Keep the unit away from children. Specifications • Keep instructions in a safe place. Power source: 100-240V AC, 50- • The unit is applied to the Chinese 60Hz (Automatic standard GB4706.1 appendix B voltage conversion) and GB4706.9. Motor voltage: 3.6 V DC •... - Page 16 Matsushita Electric Works, Ltd. 1048, Kadoma, Osaka 571-8686, Japan No.4 EN, CH（中国） Printed in Japan...