Mazda mx-5 2017 Owner's Manual page 442

If Trouble Arises
Flat Tire
10. Install the bottle to the air compressor
and press it in until the left and right
tabs are engaged securely.
11. Insert the air compressor plug into the
accessory socket inside the vehicle and
switch the ignition to ACC.
Refer to Accessory Sockets on page
5-134.
CAUTION
When inserting the air compressor
plug into or removing it from the
accessory socket, make sure that the
air compressor switch is off. When
turning the air compressor on/off, use
the air compressor switch.
7–8
Tabs
Compressor plug
Compressor
12. The sealant is injected into the tire
when the air compressor is switched
on. After the sealant is injected
completely, wait until the tire inflation
pressure increases to the specified tire
inflation pressure.
NOTE
The inflation pressure may increase to
about 300 kPa (3.1 kgf/cm
psi) temporarily to inject the sealant
through the valve. Normally, the inflation
pressure decreases gradually and it
reaches the actual inflation pressure after
about 30 seconds.
WARNING
Never use the air compressor above 300
kPa (3.1 kgf/cm , 3 bar, 43.5 psi):
2
Using the air compressor at an
inflation pressure above 300 kPa (3.1
kgf/cm , 3 bar, 43.5 psi) continuously
2
is dangerous. If the air compressor
overheats, hot air will be exhausted
and you could get burned.
, 3 bar, 43.5
2