Instruments
Warning / indicator lamp
Diesel engine
pre-heating
Electric parking
brake
Blind spot
monitoring
system
Park Assist
24
State
Cause
fixed.
The "START/STOP" switch has been
pressed (ignition on).
fixed.
The electric parking brake is applied.
fixed.
The blind spot monitoring system has
been activated.
fixed.
The Park Assist function has been
activated.
Action / Observations
Wait until the indicator lamp goes off before starting.
Once it goes off, starting is immediate, on condition
that you maintain pressure on the brake pedal for an
automatic gearbox, or the clutch pedal is pressed fully
down for a manual gearbox.
The period of illumination of the indicator lamp is
determined by the ambient conditions (up to about
thirty seconds in extreme conditions).
If the engine does not start, switch the ignition off and
then on, wait until the indicator lamp goes off again,
then start the engine.
Release the electric parking brake to switch off the
warning lamp: with your foot on the brake pedal,
briefly push the electric parking brake control lever.
Observe the safety recommendations.
For more information on the Electric parking brake,
refer to the corresponding section.
For more information on the Blind spot monitoring
system, refer to the corresponding section.
For more information on Park Assist, refer to the
corresponding section.