Maytag DWU9921AAE Use & Care Manual page 11

Delay/Resume Display Window
Pressing the Delay/Resume Pad can delay or This display- window tells what is happening in
interrupt any wash cycle from 10 minutes to 12 the dishwasher. Phases of the cycle and minutes
hours, remaining are displayed.
To set up a delay, first select the appropriate Cycle Sequence Indicator:
cycle and options for the load. Then, quickly The six segment vertical bar and words
press and hold the Delay/Resume pad until the represent the portions of the cycle to indicate
desired amount of delay time appears in the the phase of the cycle in progress--PRE-
display. When pressed, 10 MIN. will appear WASH, WASH, RINSE, or DRY. At the end of
indicating a 10 minute delay and increase in 10 the dry phase CLEAN will remain lit until the
minute increments until 1HOUR is reached, door has been opened longer than 30 seconds.
Further increases in the display will be in one
hour increments until 12 hours is reached. Special Indicators:
DELAY will remain in the display" until the RINSED ONLY- appears after a Rinse & Hold
clock has counted down. The cycle will cycle.
autmoatically start as soon as the delay time HEATING DELAY - appears when Temp
expires. Boost Sensor is selected and the cycle is being
If you wish to cancel the delay start simply press extended because the water temperature is low.
the Delay/Resume pad again. The indicator DELAY - appears when the Delay/Resume pad
light will go out and the cycle will start is pressed to show the time length of the delay.
immediately.
PF - appears when there has been a power
NOTE: If delay is chosen without first failure. Press any pad to clear.
selecting a cycle and options, the
_asher will select the last wash
cycle used in the delay mode. Adding a Forgotten Item
This pad can also be pressed to temporarily For best cleaniug, the forgotten item should be
interrupt a cycle. The cycle wiI1 resume frmn added early in the cycle.
the point of interruption when the delay time 1. Unlatch the door and wait until the souud of
runs out or when the DelayResume pad is circulating water stops.
pressed again.
2. Open the door and add the item.
To Start Dishwasher 3. Pause before latching the door. The cycle will
After loading close the door; press the door until continue at the point it was interrupted.
it latches.
NOTE: Run the water from the hot water tap to
clear the line of cold water before
starting.
Turn the dishwasher on by firmly pressing the
pad corresponding with the chosen cycle.
Pressing Power Scrub, Normal Cycle,
Light/Chiua, Quick Cycle or Rinse & Hold wiI1
start the dishwasher (fill will begin). The
indicator light for the selected cycle will glow.
PAGE 10