Select Cycle Modifiers; Touch Power To Turn On Washer - Whirlpool WTW9500EW Use & Care Manual

6.
Add liquid fabric softener to
dispenser
Pour a measured amount of liquid fabric softener into
dispenser; always follow manufacturer's directions for
correct amount of fabric softener based on your load size.
Fabric Softener is added during rinse.
IMPORTANT: Do not overfill or dilute. Overfilling dispenser
will cause fabric softener to immediately dispense into
washer. Do not put fabric softener crystals into dispenser.
If Extra Rinse option is selected, fabric softener will be
dispensed into the last rinse. It is normal for a small amount
of water to remain in the dispenser at the end of a cycle.
7.

Touch POWER to turn on washer

Make sure the Load & Go™ dispenser drawer is closed
completely, then close the lid and touch POWER to turn on
the washer.
8.
Select the type of load to wash
First touch a cycle from the "What to
Wash" and then select the "How to Wash"
to get the best combination cycle available
for the type of items you are going to wash.
See "Cycle Guide" for cycle details. Red,
green, and blue LED lights come on below
the time/status display when the "How to
Wash" ColorLast cycle is selected. Not all
cycles are available on all models.
Estimated Time Remaining will light up with a cycle time.
You may notice time adjusting during the cycle. This is normal.
If you do not want to begin a cycle immediately, you may
choose DELAY START option.
To choose a delay time:
1. Touch DELAY START button to select desired delay time.
Time will increase in hour increments up to 12 hours.
2. Press and hold the START/PAUSE button to start delay start
time.
IMPORTANT: When delaying a cycle, use liquid HE
detergent only in the dispenser. Powdered detergents may
absorb moisture from a previous cycle and clump before the
wash cycle begins.
To cancel delay start:
1. Touch POWER to cancel Delay Start.
To pause delay start:
1. Touch START/PAUSE button to pause delay start.
2. Touch START/PAUSE button again to start Delay Start time.
9.

Select cycle modifiers

Once you select a cycle, the default modifiers or the previous
set modifiers for that cycle will be lit. Touch the cycle settings
buttons to change the Soil Level, Spin Speed, and Temperature,
if desired. Not all settings are available with
all cycles.
NOTE: Always read and follow fabric care labels instructions
to avoid damage to your items. If not sure on which
temperature to use, refer to the chart below or select
a cooler temperature.
Temperature suggestions
Light soils
Colors that
bleed or fade
NOTE: Even for cold wash settings, some warm water
may be added to the washer to maintain a minimum
temperature.
Moderate soils Heavy Soils
Bright colors Whites
Pastels
11