Making Antenna Connections - Sony KP-41 EXR96 Operating Instructions Manual

Making Antenna Connections
Although you can use either an indoor or outdoor antenna with the projection TV, an outdoor antenna will
provide you with better picture quality.
You can receive cable TV by connecting a cable supplied by your local cable company.
Check yourantenna cable type. If you have 75-ohm coaxialcable (round),attachan F-type connector(not
supplied).If you have 300-ohm twin-leadcable (fiat), attacha 300-75 ohm adaptor (not supplied).
,Using 75-ohm coaxial cable (round)
Prepare the end of the cable by attaching the F-type
connector as shown below.
a
7 mm 11/4 i nch) 10 mm (¾ inch) •
. i
F-type connector
3 mm (1,,_ i nch)
Plug the connector into the VHF/UHF terminal at the rear of the projection TV.
Using 300-ohm twin-lead cable ('flat)
Prepare the end of the cable by attaching the 300-75
ohm adaptor as shown below.
:
-
w
w
Loosen with
a screwdriver.
_----_ 300-75 ohn_t
-
Attachthe
cable and
fastenwith a
screwdriver.
Plug the adaptor into the VHF/UHF terminal at the rear of the projection TV.
N
3"
.-J t,,_
o
(Rear of projection TV)
VHF/UHF
(Rear of projection TV)
VHF./UHF
* Most combination antennas are equipped with a signal splitter.
Remove the splitter and attach the appropriate connector.
Chapter 1: Setting Up
I 13