Label Values - Alcatel-Lucent 7210 SAS M User Manual

Service access switch
Hide thumbs Also See for 7210 SAS M:
Table of Contents

Advertisement

Label Values

Packets travelling along an LSP (see
label, the 20-bit, unsigned integer. The range is 0 through 1,048,575. Label values 0-15 are
reserved and are defined below as follows:
7210 SAS devices uses labels for MPLS, RSVP-TE, and LDP, as well as packet-based services
such as VLL and VPLS.
Label values 16 through 1,048,575 are defined as follows:
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
A value of 0 represents the IPv4 Explicit NULL Label. This Label value is legal only at
the bottom of the Label stack. It indicates that the Label stack must be popped, and the
packet forwarding must be based on the IPv4 header.
A value of 1 represents the router alert Label. This Label value is legal anywhere in the
Label stack except at the bottom. When a received packet contains this Label value at the
top of the Label stack, it is delivered to a local software module for processing. The actual
packet forwarding is determined by the Label beneath it in the stack. However, if the
packet is further forwarded, the router alert Label should be pushed back onto the Label
stack before forwarding. The use of this Label is analogous to the use of the router alert
option in IP packets. Since this Label cannot occur at the bottom of the stack, it is not
associated with a particular network layer protocol.
A value of 3 represents the Implicit NULL Label. This is a Label that a Label Switching
Router (LSR) can assign and distribute, but which never actually appears in the
encapsulation. When an LSR would otherwise replace the Label at the top of the stack
with a new Label, but the new Label is Implicit NULL, the LSR pops the stack instead of
doing the replacement. Although this value may never appear in the encapsulation, it
needs to be specified in the RSVP, so a value is reserved.
Values 4-15 are reserved for future use.
Label values 16 through 31 are reserved for future use.
Label values 32 through 1,023 are available for static assignment.
Label values 1,024 through 2,047 are reserved for future use.
Label values 2,048 through 18,431 are statically assigned for services.
Label values 32768 through 131,071 are dynamically assigned for both MPLS and
services.
Label values 131,072 through 1,048,575 are reserved for future use.
Label Switching Routers on page
MPLS and RSVP
22) are identified by its
Page 21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7210 sas mxp os7210 sas t7210 sas x7210 sas r6

Table of Contents