Connecting a PC or Mac
By connecting a computer to the USB port (USB-DAC) on the
rear panel of this unit using a commercially available USB
cable (Sold separately), this unit can be used as a D/A
converter. (v p. 20)
Type A
USB 2.0 cable
(Sold separately)
Computer on which the driver software and audio player
Type B
software are installed
Before USB connecting this unit to your computer, install
0
the driver software in your computer. (v p. 20)
Download the driver software from the SA-10 page of the
0
Marantz website.
NOTE
Use a cable that is 3 m or less to connect to the computer.
0
Connecting devices with
remote control connectors
When you use this unit connected to a Marantz amplifier, this
unit receives operation signals sent from the amplifier and
operates accordingly.
Next, configure the "Connection" and "Setting".
Connection
Use the supplied remote connector cable to connect the
REMOTE CONTROL IN connector of this unit to REMOTE
CONTROL OUT connector of the amplifier.
Setting
Turn the EXTERNAL/INTERNAL switch on the unit to
"EXTERNAL".
This setting will disable remote sensor reception of this
0
unit.
To operate the unit, point the remote control at the remote
0
sensor of the amplifier.
To use this unit by itself without connecting an amplifier,
0
turn the switch to "INTERNAL".
This unit
Remote
Set to
connector
"EXTERNAL".
cable
Signal flow
(supplied)
Amplifier
Connecting the timer device
This unit can perform timer play when an amplifier and timer
device are connected to this unit.
("Timer Play" (v p. 27))
This unit
Amplifier
To household power outlet
(AC 230V, 50/60Hz)
Timer device
Connecting the power cord
After completing all the connections, insert the power plug
into the power outlet.
To household power outlet
(AC 230 V, 50/60 Hz)
ENGLISH
Power cord (supplied)
10