Skoda citigo Owner's Manual page 36

Hide thumbs Also See for citigo:
Table of Contents

Advertisement

The following situation applies if the front or side airbag or belt tensioner
have been switched off using the vehicle system tester:
The warning light
illuminates for approx. 4 seconds after switching on the
ignition and then flashes again for approx. 12 seconds afterwards.
The following situation applies if the airbag has been switched off using the
key switch for the airbag in the front passenger storage compartment:
The warning light
comes on for a few seconds when the ignition is switch-
ed on;
The deactivated airbag is indicated by the illumination of the warning light
in the middle of the dash panel
    
the front passenger airbag.
WARNING
When a fault in the airbag system occurs, there is a risk of the system not
being triggered in the event of an accident. Therefore, this must be
checked immediately by a specialized company.
Handbrake - automatic transmission
Read and observe
on page 30 first.
If the warning light
lights up or blinks, engage the handbrake.
Further information
» page
74, Automated transmission.
Brake pedal (automatic transmission)
Read and observe
on page 30 first.
If the warning light
illuminates, operate the brake pedal.
Further information
» page
74, Automated transmission.
Turn signal system
 
Read and observe
on page 30 first.
Either the left
or the right
warning light flashes depending on the position
of the turn signal lever.
If there is a fault in the turn signal system, the warning light flashes at twice
its normal rate.
34
Using the system
Switching off the hazard warning light system is switched on will cause all of
the turn signal lights as well as both warning lights to flash.
The warning light
» page
17, Deactivating
The warning light
is operated.
/ Safety belt (belt status display) - rear seat
After switching on the ignition, illumination takes place in the display of the
instrument cluster for 30 s of the symbols  or  .
The control symbols  or  indicate whether any passengers have put on their
seat belts in the rear seats.
If a seat belt is unfastened on the rear seat during the journey at a speed of
more than 25 km/h, an acoustic signal will sound, and the belt status indicator
 for the rear seats flashes for around 30 seconds.
Further information
 City Safe Drive
If the indicator symbol  flashes rapidly, the City Safe Drive system brakes the
car brakes automatically straight away.
If the indicator symbol  flashes slowly, the system is not available or there is
a system malfunction.
Cruise control system
Read and observe
on page 30 first.
illuminates when the cruise control is active.
Main beam
Read and observe
on page 30 first.
illuminates when the main beam or the headlight flasher
Read and observe
on page 30 first.
The passenger on the associated rear seat is belted.
The passenger on the associated back seat is not wearing a seat belt.
» page
9, Seat belts.
Read and observe
on page 30 first.

Advertisement

Table of Contents
loading

Table of Contents