Package Contents; Description (Fig. 1); Electrical Safety - DeWalt DCS350 Instructions Manual

Do not incinerate the battery pack.

Package Contents

The package contains:
1 Rod cutter
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred
during transport.
• Take the time to thoroughly read and
understand this manual prior to operation.

Description (Fig. 1)

WARNING: Never modify the power
tool or any part of it. Damage or personal
injury could result.
A. Trigger switch
B. Reset/lock-off button
C. Stationary cutting die
D. Moving cutting die
E. Hex wrench
F. Hang hook
G. Battery pack
H. Battery release button
I LED worklight
J. Cutting die cap screws
INTENDED USE
The threaded rod cutter is intended for cutting
applications.
DO NOT use under wet conditions or in the
presence of flammable liquids or gases.
This rod cutter is a professional power tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
DO NOT use for cutting tempered bolts, threads of
different sizes, or reinforcing rod.
RECOMMENDED APPLICATIONS
Mild Steel
Stainless
Steel

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
e
in accordance with IEC 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
e
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm ; the maximum length is 30 m.
2
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up can
cause injury.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (Fig. 2)
NOTE: Make sure your battery pack (G) is fully
charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack (G) with the rails inside
the tool's handle (Fig. 2).
2. Slide it into the handle until the battery pack is
firmly seated in the tool and ensure that you
hear the lock snap into place.
English
Rod Size
M6 x 1
M8 x 1.25
M10 x 1.5
M12 x 1.75
M6 x 1
M8 x 1.25
M10 x 1.5
WALT battery
e
11