Ic Pre-Baking; Parts Replacement And Substitution; Rigid Circuit Boards; Chip Components - Motorola CP040 Detailed Service Manual

General Repair Procedures and Techniques
Motorola
Part Number
10-856-74C03

IC Pre-Baking

No pre-baking of components is required in the repair of this product.

Parts Replacement and Substitution

When damaged parts are replaced, identical parts should be used. If the identical replacement
component is not locally available, check the parts list for the proper Motorola part number and
order the component from the nearest Motorola Communications parts center listed in the "Piece
Parts" section of this manual.

Rigid Circuit Boards

The family of radios uses bonded, multi-layer, printed circuit boards. Since the inner layers are
not accessible, some special considerations are required when soldering and unsoldering
components. The through-plated holes may interconnect multiple layers of the printed circuit.
Therefore, care should be exercised to avoid pulling the plated circuit out of the hole.
When soldering near the 18-pin and 40-pin connectors:
■
avoid accidentally getting solder in the connector.
■
be careful not to form solder bridges between the connector pins
■
closely examine your work for shorts due to solder bridges.

Chip Components

Use either the RLN4062 Hot-Air Repair Station or the Motorola 0180381B45 Repair Station for
chip component replacement. When using the 0180381B45 Repair Station, select the TJ-65 mini-
thermojet hand piece. On either unit, adjust the temperature control to 370 °C (700 °F), and
adjust the airflow to a minimum setting. Airflow can vary due to component density.
■
To remove a chip component:
1. Use a hot-air hand piece and position the nozzle of the hand piece approximately 0.3 cm
(1/8") above the component to be removed.
2. Begin applying the hot air. Once the solder reflows, remove the component using a pair
of tweezers.
3. Using a solder wick and a soldering iron or a power desoldering station, remove the
excess solder from the pads.
■
To replace a chip component using a soldering iron:
1. Select the appropriate micro-tipped soldering iron and apply fresh solder to one of the
solder pads.
2. Using a pair of tweezers, position the new chip component in place while heating the
fresh solder.
Table 1-2. Lead Free Solder Paste Part Number List
Manufacturer
Viscosity
Part Number
NC-SMQ230 900-
1000KCPs
Brook-
field(5rpm)
Composition & Percent
Type
Type 3 95.5%Sn-3.8%Ag-0.7%Cu
(-325/ 89.3%
+500)
Liquidus
Temperat
Metal
217
Degree C
2-3
ure