LG S5000 Service Manual page 15

3. TECHNICAL BRIEF
(1) Receiver Part
The Aero I transceiver uses a low-IF receiver architecture which allows for the on chip integration of
the channel selection filters, eliminating the external RF image reject filters and the IF SAW filter
required in conventional super-heterodyne architectures.
A. RF front end
RF front end consists of Front End Module(FL500) and dual band LNAs integrated in transceiver
(U501).
he Received RF signals(GSM 925MHz ~ 960MHz, DCS 1805MHz ~ 1880MHz PCS 1905MHz ~
1980MHz) are fed into the antenna or Mobile switch.
The Front End Module(FL500) is used to control the Rx and Tx paths. And, the input signals VC1,
VC2, VC3 of a FL500 are directly connected to baseband controller to switch either Tx or Rx path on.
The logic and current is given below Table 3-1
GSM Tx
DCS, PCS Tx
GSM / DCS Rx
GSM / DCS Rx
Three differential-input LNAs are integrated in SI4205. The GSM input supports the GSM 850 (864-
894MHz) or E-GSM 900 (925-960MHz) bands. The DCS input supports the DCS 1800 (1805-1880
MHz) band. The PCS input supports the PCS 1900 (1930-1990 MHz) band.
The LNA inputs are matched to the 150 balanced output SAW filters through external LC matching
networks. The LNA gain is controlled with the LNAG[1:0] and LNAC[1:0] bits in register 05h (Figure 3-2).
Table 3-1 THE LOGIC AND CURRENT
VC1
0 V
0 V 2.5 ~ 3.0 V
0 V
2.5 ~ 3.0 V
- 16 -
VC2
0 V
0 V
0 V
VC3
2.5 ~ 3.0 V
0 V
0 V
0V