Z.2.5 Precautions during Calibration
Observe the following while the READY status lamp of the flat panel sensor is blinking, as it is being
calibrated.
• Do not subject the flat panel sensor to shock.
• Do not deliver radiation.
• Do not connect or disconnect the connector.
Z.2.6 Precautions for Exposing the Flat Panel Sensor to X-ray
When you expose the flat panel sensor to X-ray at any other time except during radiography,
artifacts could appear in the image. If artifacts appeared in the image due to X-ray irradiation,
perform a test X-ray radiography after waiting for more than 2 minutes and then restart exposure
after confirming that the artifacts disappear.
Z-4
DR-ID 670 Operation Manual
897N102735