Assembly Instruction - JLL CT100 Owner's Manual

STEP 1:
Tighten the Front Stabiliser (2) and Rear Stabiliser (3) to the Mainframe (1) with the Carriage Bolt
(46), Arc Washer (49) and Acorn nut (47).
STEP 2:
Tighten the Coupler bar (4L) (4R) to the Mainframe (1) with the Handlebar shaft (12) using the Inner
Hexagon Screw (57), spring washer (52), "D" shape washer (56) and Flat Washer (66).
Then tighten the Pedal support to the Mainframe with Pedal hinge bolt (61 L&R), spring washer (51)
and Nylon Nut (48).
Lastly cover the Pedal Support with the Plastic Caps (64), (65).
Note: The left bolt will thread on in an anti-clockwise direction.
The right bolt will thread in a clockwise direction.

Assembly Instruction

HINT: There is a left and right bolt for the
pedal. This are identified with an 'L' or an 'R'.
5