Copy Configuration Files Using Snmp - Dell S4048T Configuration Manual

Following is the sample audit log message that other syslog servers that are reachable receive:
Oct 21 00:46:13: dv-fedgov-s4810-6: %EVL-6-NOT_REACHABLE:Syslog server
10.11.226.121 (port: 9140) is not reachable
Following example shows the SNMP trap that is sent when connectivity to the syslog server is resumed:
DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (10230) 0:01:42.30
MIB::snmpTrapOID.0 = OID: SNMPv2-
SMI::enterprises.6027.3.30.1.1.2
STRING: "REACHABLE: Syslog server
10.11.226.121 (port: 9140) is reachable"SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 =
INTEGER: 2
Following is the sample audit log message that other syslog servers that are reachable receive:
Oct 21 05:26:04: dv-fedgov-s4810-6: %EVL-6-REACHABLE:Syslog server 10.11.226.121
(port: 9140) is reachable

Copy Configuration Files Using SNMP

To do the following, use SNMP from a remote client.
• copy the running-config file to the startup-config file
• copy configuration files from the Dell Networking system to a server
• copy configuration files from a server to the Dell Networking system
You can perform all of these tasks using IPv4 or IPv6 addresses. The examples in this section use IPv4
addresses; however, you can substitute IPv6 addresses for the IPv4 addresses in all of the examples.
The following table lists the relevant MIBs for these functions are.
Table 86. MIB Objects for Copying Configuration Files via SNMP
MIB Object
copySrcFileType
copySrcFileLocation
OID
.
1.3.6.1.4.1.6027.3.5.1.1.1.1.
2
.
1.3.6.1.4.1.6027.3.5.1.1.1.1.
3
SNMPv2-SMI::enterprises.6027.3.30.1.1 =
Object Values
1 = Dell Networking OS
file
2 = running-config
3 = startup-config
1 = flash
2 = slot0
Simple Network Management Protocol (SNMP)
SNMPv2-
Description
Specifies the type of file
to copy from. The range
is:
• If copySrcFileType is
running-config or
startup-config, the
default
copySrcFileLocation
is flash.
• If copySrcFileType is
a binary file, you
must also specify
copySrcFileLocation
and
copySrcFileName.
Specifies the location of
source file.
• If
copySrcFileLocation
991