Status Indicators - Sharp AR-F152 Operation Manual

STATUS INDICATORS

STATUS INDICATORS STATUS INDICATORS
STATUS INDICATORS STATUS INDICATORS
Be sure to use only genuine SHARP parts
and supplies.
When the following indicators light up or blink on the operation panel or the following symbols appear in the display,
solve the problem immediately referring to both the table below and the relevant page.
Indication Indication Indication Indication Indication
Developer replacement
q
required indicator
Toner cartridge replace-
ment required indicator
s
Misfeed indicator
t
SPF / R-SPF misfeed
indicator
Maintenance indicator
The paper tray indicator
q
is blinking.
„CH" is blinking in
the display.
n
„CH" is steadily lit in
the display.
„P" is blinking in
Q
the display.
A letter and a number
appear alternately.
The memory backup funtion for facsimile maintains data only for one hour. When any facsimile data
is kept in memory,do not keep the copier power turned off (by unplugging the power cable) for a long
time even if the copier stops due to trouble. (AR-F152)
DISPLAYING TOTAL NUMBER OF COPIES DISPLAYING TOTAL NUMBER OF COPIES DISPLAYING TOTAL NUMBER OF COPIES DISPLAYING TOTAL NUMBER OF COPIES DISPLAYING TOTAL NUMBER OF COPIES
Use the following procedure to display the total number of copies.
AR-151 156 F152 121E 151E NON EU GB-H 1.p65
Cause and remedy Cause and remedy Cause and remedy
Cause and remedy Cause and remedy
Steadily Developer is required. Contact your SHARP service centre as soon
lit as possible.
Replacement of toner cartridge will be needed soon. Obtain a
Steadily
lit new cartridge. p. 1-20
Blinking Toner cartridge must be replaced. Replace it with a new one.
p. 1-20
Blinking A misfeed has occurred. Remove the misfed paper referring to
the description of „Misfeed removal." p. 1-23. Lever of fusing area
is not raised. p. 1-24 The lower side cover may be open. If so, close it.
Blinking An original misfeed has occurred in the SPF or in the R-SPF.
Remove the misfed originals referring to the description of
"Misfeed in the SPF or in the R-SPF". p. 1-26.
Steadily Service by an authorized SHARP service technician is required.
lit p.1-25.
The paper tray is not installed properly. Push the tray into the
copier securely. p.1-7.
The toner cartridge is not installed. Install the toner cartridge.
If „CH" is blinking even if the cartridge is installed properly,
contact your SHARP service centre immediately. p. 1-20
Side cover is open. Close the side cover securely by pressing the
round projections near the side cover open button. p. 1-21
Paper tray or bypass tray is empty. Load copy paper. p. 1-7
A misfeed has occurred in the paper tray or bypass tray. Remo-
ve the misfed paper. p. 1-24
Paper tray is not securely installed. Push the tray in securely.
p. 1-7
The copier will not function. Turn the power switch off and then
switch it on,and if there is again an error, remove the power cord
from the outlet, and contact your authorized Service representative.
>
1. Press the clear ( ) key to reset the
display to zero.
2. Press and hold down the clear (
for approximately 5 seconds. The total
number of copies will appear in two
steps, each with three digits.
Example:
Total number of copies is 1,234.
29
>
) key
09/01/01, 11:43
1 1 1 1 1 – – – – – 29 29 29 29
29