Automatic Mode - NEC Univerge sv8500 Manual

If the Mute key is pressed, when the mute function is set to ON, the voice at the Desk Console side is not sent
to the other party.
(a) Press the desired number. An asterisk (*) shows the selected number.
1. Both the H/S0 mute function and the H/S1 mute function are set to On
2. Only the H/S0 mute function is set to On
3. Only the H/S1 mute function is set to On
SRC: Return to the Configuration Menu
The default setting is "1: H/S0 ON, H/S1 ON".
Note 1:
(b) Press the SRC key. The display returns to the first page of the Configuration Menu.
(c) To assign data to additional configuration items, refer to the Selecting a Configuration Item section.
When finished, proceed to the Updating the Configuration Data section.
4. REC CONTROL
This item specifies the operation mode of a recording device. The following two modes are available:
Manual Mode
Manual mode is available when the RECC (PA-M87) circuit card is mounted in the system. When the REC
key is pressed, the system starts recording and the REC lamp lights. When the REC key is pressed again,
the recording stops and the REC lamp goes off.

Automatic Mode

In Automatic mode, the system starts or stops recording automatically, when a call is connected/
disconnected. Note that the REC key is not effective in Automatic mode.
(a) Press the desired number. An asterisk (*) shows the selected number.
[MUTE]
*1: H/S0 ON, H/S1 ON
2: H/S0 ON, H/S1 OFF
3: H/S0 OFF, H/S1 ON
[CONFIG MENU P1] VER x
1: HEADSET/HANDSET
2: HEADSET TYPE
3: MUTE
[REC CONTROL]
*1: MANUAL
Note 1
VOL.3-506
CHAPTER 4
SRC: menu
Note 1
SRC: prev page
DEST: next page
Release: exit
Answer: update
SRC: menu
CONFIGURATION SETUP