Technics RS-TR575 Operating Instructions Manual page 22

Troubleshooting guide
Before requesting service for this unit, check the chart below for the directory of Authorized Service Centers (enclosed with this unit)
a possible cause of the problem you are experiencing. Some sim ­ to locate a convenient service center, or consult your Technics
ple checks or a minor adjustment on your part many eliminate dealer for instructions.
the problem and restore proper operation.
(In U.S .A. consult PASC Authorized Servicenters for detailed
II you are in doubt about some of the check points, or if the instructions.)
remedies indicated in the chart do not solve the problem, refer to
Problem Probable cause{s) Suggested remedy
Tape moves but no sound Is The volume control of the receiver is set to its • Adjust the volume control to the desired level.
heard_ minimum position.
The input selector of the receiver is not set to the • Set to the "TAPE" position.
"TAPE" position.
Distorted sound. The recording level is too high .
• Select the appropriate recording level.
Previously recorded sound Erase head is dirty.
• Clean the head.
has not been erased.
Sound output Is hoarse or Heads are dirty. • Clean the heads.
unsteady.
Tape is damaged .
• Try operation with a new cassette; if there is no
problem with the new cassette, discard the damaged
cassette.
Poor sound quality The correct Dolby noise-reduction button is not • Set it to the correct position .
(especially In the high set.
treble and low bass ranges).
Sound Is low, poor tone, Heads, capstan and/or pinch roller are dirty or • Clean the heads, capstan and/or pinch roller, or try a
Intermittent sound noise. tape is damaged.
new cassette.
A "hum" noise Is heard This unit is placed too close to a receiver, • Leave as much space as possible between the units,
during tape playback or amplifier or tuner.
or place them where there is the least amount of
recording.
"hum".
Recording Is not possible. The recording level control is at the "0" position.
• Select the appropriate recording level.
One of the tape-to-tape recording-speed • Switch OFF whichever tape-to-tape recording speed
indicators (" x 1" or "G]J") is illuminated. indicator is illuminated (by pressing the SPEED
button).
TV noise Is accidentally This unit is placed near a TV. • Try placing this unit further away from a TV.
recorded.
22