Device In The 5.25-Inch Flex Module - Lenovo ThinkStation P910 User Manual

6. Slide the flex bay storage enclosure into the optical drive bay. See "Device in an optical-drive bay"
on page 65.
7. Connect the signal cable and the power cable to the new storage drive.
Figure 25. Connecting the cables to the storage drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 130.

Device in the 5.25-inch flex module

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
This section provides instructions on how to install or replace a device in the 5.25-inch flex module. Installing
and replacing a device in the 5.25-inch flex module involves the following operations:
• "Slim optical drive" on page 73
• "Card reader" on page 76
• "eSATA connector or IEEE 1394 connector" on page 79
Slim optical drive
To install or replace a slim optical drive in the flex module, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 59.
2. Remove the flex module from the front of the computer. See "Device in an optical-drive bay" on page 65.
.
Chapter 7 Installing or replacing hardware
73