Configure Route For Oob Management Port (Optional); Configure Login Credentials; Configuring Switch Ports - Dell S4048-ON Configuration Manual

5.7

Configure route for OOB management port (optional)

Dell(conf)#management route X.Y.Z.0 /24 A.B.C.1
X.Y.Z.0
Note:
the switch. If your management system is on the same subnet as the switch, the previous step may be
omitted. The previous example assumes a class C subnet mask.
5.8

Configure login credentials

Dell(conf)#username admin privilege 15 password 0 yourpassword
Dell(conf)#enable password level 15 0 yourpassword
5.9

Configuring switch ports

Dell(conf)#interface range tengigabitethernet 1/1–1/48
Dell(conf-if-range-te-1/1-48)#mtu 12000
Dell(conf-if-range-te-1/1-48)#switchport
Dell(conf-if-range-te-1/1-48)#spanning-tree rstp edge-port
Dell(conf-if-range-te-1/1-48)#flowcontrol rx on tx off
Dell(conf-if-range-te-1/1-48)#no shutdown
Dell(conf-if-range-te-1/1-48)#exit
Dell(conf)#interface range tengigabitethernet 2/1–2/48
Dell(conf-if-range-te-2/1-2/48)#mtu 12000
Dell(conf-if-range-te-2/1-2/48)#switchport
Dell(conf-if-range-te-2/1-2/48)#spanning-tree rstp edge-port
Dell(conf-if-range-te-2/1-2/48)#flowcontrol rx on tx off
Dell(conf-if-range-te-2/1-2/48)#no shut
Dell(conf-if-range-te-2/1-2/48)#exit
Dell(conf)# protocol spanning-tree rstp
Dell(conf-rstp)#no disable
Dell(conf-rstp)#exit
Dell(conf)#exit
17 SCG1026 Dell Networking S4048-ON Switch Configuration Guide for PS Series SANs
is the network your management system is connecting from and
A.B.C.1
is the gateway for