EP3203-U1
10.13.6. Removing the Air unit
1. Disconnect Connectors (CN201, CN208) of the Main PCB.
2. Unscrew five screws of the Main PCB installation plate and four screws of the Air unit.
3. Cut off the Insulated tie medium of the Air hoses.
Caution when installing
· You can remove the Air unit with the five screws loose of the Main PCB installation plate.
10.13.7. Removing the Width motor
1. Disconnect Connectors (CN102, CN500) of the Main PCB.
2. Cut off one Insulated tie medium, and two small.
3. Remove the Width belt.
4. Unscrew four screws of the Width motor.
10.13.8. Removing the Back vibrator (EP3203 Only)
1. Disconnect Connectors (CN2102, CN211) of the Main PCB.
2. Cut off three Insulated ties medium of the Lead wires.
3. Unscrew two screws of the Back vibrator.
Caution when removing
· It would be easy to remove the Air unit if you set the Massage balls at widest and strongest.
46