Kenmore 146. 34436410 Use & Care Manual page 19

Module Head to Cart
□ This step requires two people to lift and position module head onto cart.
□ Raise the burner lids, and remove the packaging and grates underneath. Set the grates aside. Remove the
tie wraps and packaging from the regulator hose on the underside of the module head.
□ Carefully lower the module head onto the cart. Make sure the regulator hose is hanging into the cart.
Attach module head to cart with(6) M4x10 screws.
Front Doors
□ Remove the (4) M5x15 screws pre-assembled to the door handle ends, and use them to
attach handles to doors.
□ For each door, insert the bottom hinge pin into the hole in the front bottom of the cart. Push the
top hinge pin down into the door, align it with the top hinge pin hole, and let the pin pop back
up, securing the door in position.
M4X10 screws Qty: 6 pcs
34436-00500120 • 19