Fig.3.6 Removal Of Power Transformer - Epson MX-80 Technical Manual

(3) Dismounting of power transformer
The power transformer is secured to the lower case with two screws, and its electrostatic
shield wire on the primary side is also secured to the lower case with a screw. Therefore,
the power transformer can be dismounted simply as outlined below.
STEP 1. Unplug the connector CDextending from the power transformer to the fuse and
filter circuit board and remove the screw
CV
securing the electrostatic shield
wire. (See Fig. 3.6.)
NOTE: For the 220/240V specification, this shield wire is not provided.
STEP 2. Remove the two screws
@
securing the power transformer, (See Fig. 3.6.)
STEP 3. Remove the power transformer.
Fig. 3.6 Removal of Power Transformer
3-7
REV. A