Table of Contents
Advertisement
Installing/Removing
Headstock Center
The spur center installs in the headstock spindle
with an MT#2 taper fit.
Tools Needed:
Gloves ............................................................... 1
Knockout Rod .................................................... 1
Installing Headstock Center
1.
DISCONNECT MACHINE FROM POWER!
2.
Make sure surface of center and spindle are
free of debris and oily substances before
inserting center.
3.
Insert tapered end of center into spindle, and
push it in quickly and firmly (see Figure 25).
Spur center is sharp and may cause cuts.
Wear gloves when installing spur center.
Figure 25. Typical installation of spur center into
headstock.
4.
Check that center is securely installed by giv-
ing it a quick tug. (A properly installed center
will not pull out by hand.)
Model T25920/T25926 (Mfd. Since 08/14)
Spur Center
Removing Headstock Center
1.
DISCONNECT MACHINE FROM POWER!
2.
Insert knockout rod into outboard end of spin-
dle. Use a shop rag or wear a glove to catch
center and gently tap rod handle until spur
center is freed from spindle (see Figure 26).
Knockout Rod
Figure 26. Typical spur center removal from
headstock spindle.
Installing/Removing
Tailstock Center
The included live center installs into the tailstock
with an MT#2 tapered fit.
Installing Live Center in Tailstock
1.
Loosen quill lock handle (if locked) approxi-
mately half a turn.
2.
Rotate quill handwheel clockwise until quill
protrudes about
⁄
3
4
Spur Center
".
-21-
Advertisement
Table of Contents
