Removing/Installing Faceplate - Grizzly T25920 Owner's Manual

3. Insert live center, as shown in Figure 27,
and push firmly.
Quill Lock Lever
Quill
Live Center
Figure 27. Typical live center installation.
4.
Tighten quill lock handle.
Removing Live Center from Tailstock
1. Loosen quill lock handle (if locked) approxi-
mately half a turn.
2. Turn quill handwheel counterclockwise until
tailstock quill fully retracts, causing live center
to be forced out of quill.
Tailstock quill must always be locked during
lathe operation. Workpiece can be thrown
from lathe if this step is not observed. Also,
tailstock quill should not protrude from
tailstock housing more than 2'' or quill will
not be supported enough. Failure to follow
warnings may result in personal injury.
-22-
Quill
Handwheel
Removing/Installing
Faceplate
These instructions cover removing and installing
the faceplate. To mount a workpiece to your face-
plate, refer to Faceplate Turning on Page 26.
Removing Faceplate
1.
DISCONNECT MACHINE FROM POWER!
2.
Hold headstock handwheel securely while
turning faceplate counterclockwise until it is
removed. If the spur center is installed, it will
be removed during this process.
Headstock
Handwheel
Figure 28. Typical faceplate removal.
Installing Faceplate
1. DISCONNECT MACHINE FROM POWER!
2. Thread faceplate onto spindle shaft until
secure against shoulder on spindle shaft.
Model T25920/T25926 (Mfd. Since 08/14)
Faceplate