12.3.5.2. Recording Paper Feed
No.
Symptom
1
Multiple Feed (P.139)
2
The Recording Paper Is
Waved or Wrinkled (P.140)
3
Skew (P.141)
4
The
Recording
Paper
Does Not Feed (P.142)
5
The Recording Paper Jam
(P.143)
"PAPER
JAMMED"
THE LCD
6
Back Side of The Record-
ing Paper is Dirty (P.144)
Cause
Dirty or failed the pickup roller
Dirty or failed the pickup rubber
Dirty the pressure roller or the heat roller
Failed the spring of pressure roller
Separator of heat roller a check
Dust on the recording paper path
Too thin recording paper
Dirty or failed the pickup roller
Dirty or failed the pickup rubber
Dirty or failed the paper feed roller
Dust on the recording paper path
Failed LSU
Over the max capacity of the recording paper
Too thick or too thin recording paper
Dirty or failed the pickup roller
Dirty or failed the pickup rubber
Failed the gear
Failed the solenoid
Failed the engine motor
Failed the pickup sensor lever
Failed the pickup sensor
Dirty or failed the pressure roller
Dirty or failed the heat roller
ON
Failed the separator of heat roller
Dust on the recording paper path
Failed the paper feed roller
Failed the pickup sensor lever
Failed the pickup sensor
Failed the registration sensor lever
Failed the registration sensor
Failed the exit sensor
Too thick or too thin recording paper
Dirty the recording paper path
Dirty the pressure roller
Dirty the regist roller
Failed the high-voltage terminal
Failed the high voltage power supply board
KX-MB1520FX7/KX-MB1520FX8/KX-MB1520FXW/KX-MB1530FX7/KX-MB1530FXW
Clean or replace the pickup roller
Clean or replace the separation rubber
Clean the pressure roller and the heat roller
Replace the spring of pressure roller
Replace separator
Clean the recording paper path
Use the recording paper from 16lb to 24lb
Clean or replace the pickup roller
Clean or replace the separation rubber
Clean or replace the regist roller
Clean the recording paper path
Replace LSU
Set up to MAX 250 sheets
Use the recording paper from 16lb to 24lb
Clean or replace the pickup roller
Clean or replace the separation rubber
Check the gear
Check the solenoid
Go to Motor Section (P.178)
Check the pickup sensor lever
Go to Sensor Section (P.173)
Clean or replace the pressure roller
Clean or replace the heat roller
Replace separator
Clean the recording paper path
Replace the registration roller
Check the pickup sensor lever
Go to Sensor Section (P.173)
Check the Registration & Manual paper sensor (paper top sen-
sor) lever
Go to Sensor Section (P.173)
Check the Paper Exit sensor lever
Use the recording paper from 16lb to 24lb
Clean the recording paper path
Clean the pressure roller
Clean the registration roller
Check the high-voltage terminal
Go to High Voltage Section (P.187)
125
Countermeasure