Table of Contents
Advertisement
To use WEP, the encryption key must be configured as part of the profile before connecting. For more information about
configuring a profile, see
To Create a New Profile
Field
Description
*Authentication
This drop-down list is active and configurable only when the WEP Key is enabled for the selected
SSID profile. If this drop-down list is active, select one of the following options:
Algorithm
Open (This is the default selection.)
Shared
Encryption
Select the encryption type:
Disabled for no encryption
WEP to use WEP encryption
Enable 802.1X
This option and drop-down list is active only when the WEP Key is enabled.
Properties
Tap to choose the certificate that applies. Accessing 802.1x networks require personal certificates for
authentication.
Encryption Tab
The Encryption tab configures the WEP Parameters.
Field
Description
Method
The options in this drop-down list determine what characters can be used to create the WEP
encryption key in the Encryption Key field. Select one of the following five:
HEX – Hexadecimal is a set of 16 characters from 0-9 and from A(a)-F(f).
ASCII – Any printable ASCII character can be typed.
Key 1–4
Enter the WEP keys.
Dolphin® 7600 Series User's Guide -
Second Draft Preliminary
on page
•
Disabled – WEP Key is off
•
64 bit (HEX) uses 10 characters in Hexadecimal
•
64 bit (ASCII) uses 5 characters in ASCII
•
128 bit (HEX) uses 26 characters in Hexadecimal
•
128 bit (ASCII) uses 13 characters in ASCII
8-5.
Rev (a)
8 - 7
Advertisement
Table of Contents
