Dolphin 7600 Series User Manual page 23

3. Unscrew both screws on the access door.
4. When the access door is open, slide the mini-SD card into the appropriate slot until it clicks into place.
Rubber Gasket
To remove an installed mini-SD card, tap on the edge lightly to unlock the card; the card will pop out just enough
for you to grab its edge and pull it out.
5. Replace the access door and tighten the screws.
There is a rubber gasket on the inside of access door that must be in place when you seal the door. This gasket performs
the sealing action for the door.
6. Tap the Blue + Backlight keys to resume operation.
Do NOT resume terminal operation while the access door is open! Operating the terminal while the access door is open
!
will void the warranty.When closed, the access door seals the memory interface from moisture and particle intrusion thus
preserving the terminal's environmental rating. The access door must be properly sealed before resuming terminal
operation. Failure to seal the access door will void the warranty.
7. To verify that the operating system recognizes the new memory card, tap Start > Settings > Control Panel > System >
Memory tab.
Dolphin® 7600 Series User's Guide -
Second Draft Preliminary
Rev (a) 3 - 7