Zte h560n Quick Start Quide page 10

2. Input security key and click Connect. There is no security key setting by default. You can access
it without input security key. If the security key is set, you must enter the correct key and click
Connect.
4. Then the status of the wireless connection will be changed into Connected, your H560N is successfully
accessed.
7
Configuring the AP/Router
1. Set the slide switch on side to AP mode
2. Start a web browser, enter 192.168.1.253 in the address bar, then enter the username and
password, and click log in. (The default username and password are admin). Please note, In
this mode, Ethernet port only can be used as WAN port, You only can use wireless terminal to
access H560N. In default mode the DHCP is off, Please set a static IP 192.168.1.x to your
computer.
3. The router web configuration widow is displayed, click Enter wizard for Quick Setup.
- 10 -