Guide To Commissioning Fail-Safe Signal Modules - Siemens S7-300 Installation And Operating Manual

1.3

Guide to commissioning fail-safe signal modules

Introduction
The table below lists all important tasks related to the commissioning of fail-safe signal
modules in S7-300 or ET 200M.
Commissioning sequence, starting with the selection of the F-SMs
Table 1- 5
Step
1.
2.
3.
4.
5.
6.
Fail-safe signal modules
Installation and Operating Manual, 01/2010, A5E00085586-10
Commissioning sequence, starting with the selection of the F-SMs
Procedure
Selecting the F-SMs to be installed
Setup of the mode of operation (standard or safety mode),
configuration and parameterization of the F-SM
Installing F-SMs
Wiring the F-SMs
Commissioning of the F-SMs
Run diagnostics if commissioning was not successfully
completed.
1.3 Guide to commissioning fail-safe signal modules
Product overview
See
Product catalog;
Digital modules;
chapter
Analog module
chapter
Configuring and
Chapter
parameter assignment;
Addressing and
chapter
installing
Addressing and
Chapter
installing
Wiring
Chapter
ET 200M Distributed I/O
Device S7-300,
manual, or
CPU 31xC and CPU 31x
Operating Manual
Installation
Fault reactions and
Chapter
diagnostics;
Digital Module;
Chapter
Analog Module
Chapter
17