Craftsman 917.20402 Operator's Manual page 32

TO REMOVE HOOD & GRILLASSEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3, Remove retainer clip and washer from
right hand pivot pin.
4. Stand in front of tractor. Grasp hood at
sides and slide left removing hood from
pivot pins and lift hood off of tractor.
5. When replacing hood, reconnect the
headlight wire connector, and reinstall
the washer and retainer clip on the
right hand pivot pin.
Left Pivot Pin
Washer
Retainer
Right Pivot
Pin
Headlight Wire
Connector
TRANSMISSION REMOVAL/
REPLACEMENT
Should your transmissio'n requireremovalfor
service or replacement, it should be purged
after reinstaliation and before operating the
tractor, See"PURGE TRANSMISSION" in
the Operation section of this manual.
ENGINE
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, Seeengine manual.
32