Accessories - Generac Power Systems 0K2502SPFR Owner's Manual

General Information

Accessories

Performance enhancing accessories are available for air-cooled generators.
Accessory
Cold Weather Kit
Scheduled Maintenance Kit
Auxiliary Transfer Switch Lockout
Fascia Base Wrap
Mobile Link™ (USA only)
Touch-Up Paint Kit
Wireless Local Monitor
Power Management Module (PMM)
Starter Kit
Power Management Module (PMM)
Extended Warranty Coverage
NOTE: Contact an Independent Authorized Service Dealer or visit
replacement parts, accessories, and extended warranties.
10
Recommended in areas where temperatures fall below 32 ºF (0 ºC).
Includes all pieces necessary to perform maintenance on the generator along
with oil recommendations.
Enables any of the transfer switches to completely lock out one large electrical
load by tying into its control system.
The fascia base wrap snaps together around the bottom of new air-cooled
generators. This offers a sleek, contoured appearance as well as offering
protection from rodents and insects by covering the lifting holes located in the
base. Requires use of the mounting pad shipped with the generator.
Provides a personalized web portal that displays the generator status,
maintenance schedule, event history and much more. This portal is accessible
via computer, tablet or smart phone. Sends emails and/or text notifications the
moment there is any change in the generator's status. Notification settings can
be customized to what type of alert is sent and how often. For more
information, visit www.MobileLinkGen.com.
Very important to maintain the look and integrity of the generator enclosure.
This kit includes touch-up paint and instructions.
Completely wireless and battery powered, the Wireless Local Monitor provides
you with instant status without ever leaving the house. Status lights (red,
yellow and green) alert owners when the generator needs attention. Magnetic
backing permits refrigerator mounting and gives a 600 foot line of sight
communication.
Includes one module with transformer. The transformer, which is mounted inside the
ATS enclosure, interfaces with the OPCB to generate the 24 VAV signal needed for
control of the contactor (Load 1 on the OPCB).
Includes one module only. To achieve full system functionality, a total of three kits are
required to allow control of the three remaining contactors (Loads 2/3/4 on the OPCB).
Extend your generator warranty coverage by purchasing extended warranty
coverage. Covers both parts and labor. Extended coverage can be purchased
within 12 months of the end-users purchase date.
This extended coverage is applicable to registered units and end-user proof of
purchase must be available upon request.
®
Available for Generac , Guardian
available for EcoGen™ products or all international purchases.
Description
® ®
, Centurion , and Synergy™ products. Not
www.generac.com for additional information on
Owner's Manual for 60 Hz Synergy Generator™