Setup Problems
Noise After Ink Installation
Software Installation Problems
Noise After Ink Installation
•
The first time you fill the ink tanks, the product must charge its print head for about
20 minutes. Wait until charging finishes (the
the printer, or it may charge improperly and use excess ink the next time you turn it on.
•
If the printer stops moving or making noise, but the
minutes, turn off the printer. If the light is still flashing when you turn it back on, contact
Epson for help.
Software Installation Problems
•
Make sure your printer is turned on and the USB cable is securely connected at both ends. If
you still have problems, disconnect the USB cable and carefully follow the software
installation instructions on the Start Here sheet. Also make sure your system meets the
requirements.
•
Close your other programs, including any screen savers and virus protection software, and
install the software again.
•
Make sure the EPSON L800 is selected as the default printer and that the correct port is
shown in the printer properties.
•
If you see an error message or your software doesn't install correctly, you may not have
software installation privileges. Contact your System Administrator.
•
Make sure the USB Controller is working properly in Device Manager. See your Windows
help system for details. If it's not working, contact your computer manufacturer.
•
If you're printing over a network, setup network printing.
Miscellaneous Problems
Red Light Inside the Printer After Power Off
Red Light Inside the Printer After Power Off
The light may stay on for 15 minutes and then go off automatically. This is normal.
Paper Problems
Paper Does Not Feed Correctly
Paper Jams
Paper Does Not Eject or Ejects Wrinkled
Paper Does Not Feed Correctly
•
If paper doesn't feed, remove it from the sheet feeder. Reload it against the right side, behind
the tab. Slide the edge guide and against the left side of the paper, but not too tightly. Make
sure the stack of paper is not above the
power light stops flashing) before you turn off
power light is still flashing after 5
arrow marks inside the edge guide.
69