Specifications - Stihl MSE 220 Instruction Manual

English
Definitions
1. Guide Bar
Supports and guides the saw chain.
2. Oilomatic Saw Chain
A loop consisting of cutters, tie
straps and drive links.
3. Bumper Spike
Toothed stop for holding saw steady
against wood.
4. Front Hand Guard
Provides protection against
projecting branches and helps
prevent left hand from touching the
chain if it slips off the handlebar. It
also serves as the lever for chain
brake activation.
5. Front Handle (Handlebar)
Handlebar for the left hand at the
front of the saw.
6. Trigger Switch Lockout
Must be depressed before the
trigger switch can be activated.
7. Trigger Switch
Switches the motor on and off.
8. Oil Sight Glass
For visually checking the oil level.
9. Rear Handle
The support handle for the right
hand, located at the rear of the saw.
10. Rear Hand Guard
Gives added protection to
operator's right hand.
11. Oil Filler Cap
For closing the oil tank.
28
12. Chain Sprocket Cover
Covers the clutch and chain
sprocket.
13. Chain Sprocket
The toothed wheel that drives the
saw chain.
14. Overload Cutout
Interrupts power supply to the motor
when excessive infeed force is used
or when the chain is pinched in the
cut. The button jumps out. For
resetting it needs to be pushed back
in.
15. Side Chain Tensioner
Permits precise adjustment of chain
tension.
16. Chain Catcher
Helps to reduce the risk of operator
contact by a chain when it breaks or
comes off the bar.

Specifications

Motor
Voltage: 120 V
Frequency: 60 Hz
Rated current: 15 A
Power consumption: 1700 W
Fuse: 15 A
Type of enclosure: IP 20
Insulation: II E
Chain Lubrication
Fully automatic, speed-controlled oil
pump with reciprocating piston
Oil tank capacity: 0.20 l
Weight
without cutting attachment
MSE 220: 5.2 kg
Cutting Attachment
STIHL cutting attachments complying
with CSA Standard Z 62.3:
Rollomatic E guide bars
Cutting lengths: 16", 18", 20"
Pitch: 3/8" (9.32 mm)
Groove width: 1.3 mm
Nose sprocket: 11-tooth
MSE 220